Caring for the environment
37
EcoFeedback consumption in-
dicator
The Consumption function is used for
calling up information about the energy
and water consumption of your dish-
washer (see “Settings” chapter, “Con-
sumption” section).
The following information can be shown
on the display:
- An estimate of the consumption be-
fore the programme begins
- The actual consumption at the end of
the programme
- The total consumption of the dish-
washer
1. Consumption estimate
After a programme has been selected,
first the name of the programme and
after a few seconds the estimated en-
ergy consumption and water con-
sumption will appear in the display.
The estimated consumption will be
shown as a bar chart. The more bars
that are visible (), the higher the en-
ergy or water consumption.
The values are influenced by the pro-
gramme, any programme options selec-
ted, the ambient conditions and the size
of the load.
The display will change automatically
from showing the estimated consump-
tion to showing the time remaining.
The estimated consumption function is
activated as standard. This function can
be deactivated, if preferred (see “Set-
tings”, “Consumption” section).
2. Display consumption
At the end of the programme you can
call up the actual amount of energy and
water used by the programme that has
just been run.
Confirm the Consumption (OK)mes-
sage with OK.
Switching the dishwasher off at the
end of the programme will delete the
actual consumption values for the pro-
gramme that has just been run.
3. Total consumption
You can view the total consumption of
energy and water for all previously used
programmes of your dishwasher (see
“Settings” chapter, “Consumption” sec-
tion).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
