Miele G 7319 User Manual

Installation
*INSTALLATION*
105
Electrical connection
The dishwasher is supplied with a
mains cable with moulded plug ready
for connection to an earthed socket.
 Danger of suffocation due to
gases.
Connecting the dishwasher to a
multi-socket plug adapter or to an
extension lead can overload the
cable. This can cause a fire,
releasing toxic gases.
Do not use an extension lead or
multi-socket plug adapter.
 Risk of fire from overheating.
Connecting the dishwasher to a
multi-socket plug adapter or to an
extension lead can overload the
cable.
Do not use an extension lead or
multi-socket plug adapter.
The socket must be easily accessible
after the dishwasher has been
installed. If the switch is not
accessible after installation, an
additional means of disconnection
must be provided for all poles.
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from Miele) in order to avoid a
hazard. For safety reasons, such
replacement may only be carried out by
a suitably qualified and competent
technician or by Miele.
Do not connect the dishwasher to a
stand-alone inverter such as those used
with an autonomous energy source (e.g.
solar power). When the appliance is
switched on, power surges could result
in a safety switch-off. This could
damage the electronics.
The dishwasher must not be used with
so-called energy-saving devices
either. These reduce the amount of
energy supplied to the appliance,
causing it to overheat.
Before connecting the appliance, check
that the connection data on the data
plate (voltage, frequency, and fuse
rating) match the mains electricity
supply and that the installed socket
system matches that of the dishwasher.
If in any doubt, consult a qualified
electrician.
For technical data see the data plate
located on the right side of the door.
The electrical installation and all
electrical work must be carried out by a
suitably qualified and competent
person, in strict accordance with
national and local safety regulations.
For extra safety, it is advisable to install
a residual current device (RCD) with a
trip current of 30mA. Ensure power is
not supplied to the appliance until after
the installation has been completed.
Connection should be made via a
suitable switched socket.

Miele G 7319 Specifications

General

Brand	Miele
Model	G 7319
Category	Dishwasher
Language	English