Problem solving guide
88
Water intake fault
Problem Possible cause and remedy
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Turn on tap The tap is turned off.
Turn on the tap fully.
Water intake Before rectifying the problem, you must:
Switch the dishwasher off.
Water intake is restricted.
Turn on the tap fully and start the programme
again.
Clean the filter in the water inlet (see “Cleaning
and care – Cleaning the water inlet filter”).
The water connection pressure is lower than
50kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Drainage”).
Fault F18 A technical fault has occurred.
Switch the dishwasher off.
Turn off the tap.
Call Miele.
The following fault
message appears in the
display during the
SolarSaveprogramme:
Intake temperature too low
The intake water has not reached the required
temperature of 45°C (see “Installation – Water
intake”).
Restart the programme.
If the fault message appears again, select a
different programme.
To Next Page
Loading...
Need help?
General
