Operation
58
Switching on the dishwasher
Make sure the spray arms can rotate
freely.
Close the door.
Turn on the tap if it is turned off.
Touch the sensor.
If the dishwasher has been switched
off for longer than 1minute, you will
need to touch the sensor for
slightly longer (wipe protection).
When a programme is selected, it will
appear briefly in the display and the
appropriate sensor will be illuminated.
Next, the estimated energy and water
consumption may be shown for the
selected programme for several
seconds.
Then the display will show the
estimated duration for the selected
programme.
The Startsensor flashes.
Selecting a programme
Choose your programme according to
the type of crockery and the degree of
soiling.
The different programmes and their use
are described in the “Programme
chart”.
Touch the sensor for the required
programme.
The sensor for the selected programme
will light up.
Further programmes can be selected
under .
To do so, touch the sensor.
The first of the further programmes will
appear in the display.
Use the sensors in the display to
select the programme you want.
You can now select programme options
(see “Programme options”).
If any programme options are selected,
the appropriate sensor will light up.
To Next Page
Loading...
Need help?
General
