To avoid damaging the telescopic
runners, make sure that they are
pushed back into the appliance.
The dividing panel in the MasterFresh
drawer can be removed for cleaning.
^
Take the MasterFresh drawer out of
the appliance completely.
^
Pull the dividing panel in the
MasterFresh drawer up and out to
remove it.
^
After cleaning, slide the dividing
panel back into the drawer.
Please note: The MasterFresh zone
does not work as efficiently without
the dividing panel in place.
To replace the drawer
^ Pull the telescopic rails out as far as
they will go.
^ Place the MasterFresh drawer on the
rails so that it engages at the back
and front.
^
Turn the slot on the pin to its vertical
position.
^
Push the MasterFresh drawer all the
way back into the appliance.
Adjusting the door
shelves/bottle shelf
^ Hold the door shelf by its frame with
both hands, raise it a little and then
tip it forwards slightly.
^ Slide the shelf in this angled position
up or down in the side runners as
required, and then lower it into its
new position.
^
Make sure that the shelf is straight.
To remove the door shelf altogether,
^
Slide it up the side runners to the
very top, then lift it out.
To replace the door shelf
^
Engage the door shelf in the runners
at the top, and lower it to the position
required.
Arranging the interior fittings
38