^
If a wooden beam has been fitted
above the appliance to prevent
tipping, the appliance height needs
to be adjusted so that the appliance
fits snuggly under the woodden
beam.
Securing the appliance in the
niche
^
Screw the lugs for the fixing plate f
into the furniture/units above the
appliance.
If it is not possible to secure the
appliance above, it can be attached to
the housing at the sides only:
^ Pull out the lugs for the side fixing
plates g.
^ Screw on the lugs for the side plates.
^
If necessary, cut the trim h to the
necessary width.
^
Join the two bits of trim together i.
^
Click them into position j.
Installation
85