Supervisor level
34
Program selection
Controls
You can select whether the tumble dryer is operated as a “laundromat” machine. Short-
cuts are the easiest way to operate the machine. Operating staff are unable to change pre-
set programs.
Tip: Start by configuring all necessary settings and changes to the tumble dryer before ad-
justing any of the options below.
Caution: When activating any of these options, the supervisor level will no longer be
available.
You will no longer be able to access the supervisor level via the display. Please follow the
instructions below if you wish to change any other settings.
Opening the supervisor level (laundromat version)
Switch the tumble dryer on and open the dryer door.
Touch the Start/Stopsensor control and hold it down while carrying out steps–.
Close the tumble-dryer door.
Wait until the Start/Stopsensor control, which will now be flashing quickly, lights up con-
stantly...
...and then release the Start/Stopsensor control.
- Standard
Factory default: All (selected) programs are available.
- Laundromat, basic
12programs are available.
Under Favorite programs, you can set which of the 12programs to select or modify.
- Laundromat Logo
12programs are available.
Under Favorite programs, you can set which 12programs to select/modify.
- Laundromat Logo ext. time
4timed programs* with different temperature levels are time-controlled.
The set value indicates the program runtime and cannot be modified by the user.
* The maximum program runtime is specified during initial commissioning.
- Laundromat Logo int. time
4timed programs* with different temperature levels are time-controlled via the tumble
dryer’s electronic.
The set value indicates the maximum program runtime and can be modified by the user.
* The maximum program runtime is specified during initial commissioning.
- External prog. selection
A communication module can be used to select the program from an external terminal.
To Next Page
Loading...
Need help?
General