Supervisor level
35
Program packages
This allows you to specify the scope of the tumble dryer's program. You can select all of
the programs or individual programs from the relevant program packages.
The tumble dryer’s additional scope of programs can be configured. The programs are
listed under “Program overview”.
Favorite programs
After switching on, you can also select a program via: Favorites.
12programs can be stored as favorites based on your own priorities and requirements.
These favorite programs will also be made available in the control options
- Laundromat ext. (12 prog)
- Laundromat, basic (4 prog) (the first 4 of the 12favorite programs).
You can specify the control option under Controls.
Tip: You can assign a different color to each program. In this case, the Program color allo-
cationsetting must be set to On.
Changing Favorite programs
Select the program you wish to change or replace.
Confirm the program or the setting to be changed.
Another menu opens, enabling you to select a new program or change the parameters.
Confirm with the Savesensor control.
Your selection is now active.
Special programs
You can put together 5special residual-moisture or time-controlled programs and assign
your own program names.
First, enter the program name.
Select the special program you want to change.
TheSave as menu opens.
Use the letters and symbols below the line to enter the name.
Touch the Savesensor control.
You can now enter the parameters for a Res. moisture program or Timed drying.
The 5special programs are pre-programmed at the factory. You can change these special
programs.
The special programs are added to the program packages. Enter the name and settings of
your special program into the “Special programs” table in the “Program overview” chapter.
Res. moisture program:
- Final residual moisture:
-6%(dry) – 40%(damp)
- Extra drying time:
0–60minutes
To Next Page
Loading...
Need help?
General