Supervisor level
37
Moving programs/favorites
You can move/change the order of the programs (program menu – single option list). You
can also move and change the order of the favorites that you edit in the Supervisor level un-
der Favorite programs.
Touch the program that you wish to move.
Press and hold the sensor control until the frame changes.
Drag the program to the required place.
Program color allocation
You can assign a specific color to a favorite program. In the list of favorites, each favorite
program is given a colored frame, which can be adjusted.
- Factory default: Off
- On
Process technology
Anti-crease
At the end of the program, the drum will continue to rotate at intervals if the laundry is not
removed immediately.
Changing this setting leads to increased energy consumption.
The setting for Anti-crease can either be switched off or a time between 1and 12hours
can be selected.
Factory default: 2hours
Drying levels
Changing this setting leads to increased energy consumption.
You can alter the drying levels for the Cottons, Minimum Iron, and Automatic Plus programs.
Drying levels Cottons, Minimum Iron, and Automatic Plus can be set to one of 7different lev-
els.
Factory default: Normal
Additional cooling
If extended cooling is activated, the drum temperature is checked approx. 1minute before
the machine goes into standby mode at the end of the program. If the temperature is
above 130°F (55°C), the dryer will carry out cooling until it is below 130°F (55°C).
Changing this setting leads to increased energy consumption.
- Factory default: Off
- On
Cooling down temperature
The laundry will be cooled down automatically after the end of the program. The automatic
cooling phase can be set at a cooler level for all programs. This means that the cooling
phase is extended.
Changing this setting leads to increased energy consumption.
To Next Page
Loading...
Need help?
General