Miele TCJ 690 WP User Manual

6. End of programme - unloading the drum
35
At the end of the programme
The programme is finished when Finish/
Anti-crease or Finished appears in the
display. The Start/Stop sensor light
goes out.
The dryer will switch off automatically
15minutes after the end of the Anti-
crease phase (or 15minutes after the
programme with programmes without
an Anti-crease phase).
Removing the laundry
Only open the door when the drying
process has finished. Otherwise, the
laundry will not be properly dried and
cooled down.
 Reach under the door grip and pull
the door open.
 Remove the laundry.
Always remove all items from the
drum.
Items left in the dryer could be
damaged by overdrying when the
dryer is used the next time.
 Turn the programme selector to the 
position.
 Remove the fluff from the 2 fluff filters
in the door opening (see “Cleaning
and care - Fluff filters”).
 Shut the door with a gentle swing.
 Empty the condensed water
container.
Useful tip: The condensed water can
be used for the Steam care programme.
See “Condensed water container -
Preparing the condensed water
container for Steam care”.
We recommend that you drain the
condensed water externally through the
drain hose when drying a full load using
the Cottons and Cottons 
programmes. This will avoid having to
empty the condensed water container
during the programme.
Drum lighting
The lighting helps to ensure that all
items are removed from the drum.
The drum lighting will go out
automatically to save energy.

Miele TCJ 690 WP Specifications

General

Brand	Miele
Model	TCJ 690 WP
Category	Dryer
Language	English