Settings
86
Display switch-off status
To save energy the display and sensor
controls will go out after 10 minutes
and the Start/Stop sensor will flash
slowly. You can change this automatic
switch-off function.
Options
– On (factory setting)
The display will go out (after 10
minutes):
– if no programme selection is made
after switching the dryer on
– during the current programme
– after the end of a programme.
– On (not current pr.)
The display will go out (as described
above) but not while the current
programme is running.
– Off
The display will remain on (i.e. it will
never go out).
You can switch the display back on by
touching any sensor.
Memory
The dryer saves the settings that were
last selected for a drying programme
(drying level and/or Extras, or the
duration for some programmes).
The next time the programme is chosen
the saved settings will appear in the
display.
Options
– Off (factory setting)
– On
The activation of Delay start, the buzzer,
or ECO feedback data are not saved.
Anti-crease
The duration of the Anti-crease phase
can be altered.
Options
– 1 h
– 2 h (factory setting)
To Next Page
Loading...
Need help?
General
