Problem solving guide
64
General problems with the tumble dryer
Problem Possible cause and remedy
There are operating
noises (whirring/
humming).
This is not a fault.
The compressor (heat pump) is operating or you have
selected the Steam care programme.
No action is required. These are normal noises
caused by the operation of the compressor or
condensate pump.
A programme cannot be
started.
There is no obvious cause.
Connect the tumble dryer to the mains electricity
supply.
Turn on the tumble dryer.
Close the door.
Check whether the mains fuse has tripped.
Has there been a power cut? When power is
restored, any previously running programme will
restart automatically.
The display is dark and
the Start/Stop sensor is
flashing slowly.
The display has switched off automatically to save
energy (Standby mode).
The drum will rotate from time to time when the dryer
is in the Anti-crease phase.
Touch any sensor. This switches Standby off.
The dryer is switched
off at the end of the
programme.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
See “Settings - Appliance switch-off status”.
The display is in a
different language.
A different language has been selected in “Settings -
Language ”.
Set the language you want. The flag symbol serves
as a guide.
The interior drum
lighting does not come
on.
This is not a fault. The drum lighting switches off
automatically in the following cases:
If the door is closed.
If the door remains open for an extended period of
time.
To Next Page
Loading...
Need help?
General
