Settings
84
Conductivity
This setting is only relevant for regions
with very soft water.
Very soft water can result in
unsatisfactory drying results.
You should only select this setting if
the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) of less than 150μS/cm.
Contact your local water authority for
the conductivity level of your mains
water supply.
Options
– Normal (factory setting)
– Low <150mS (only for regions with
very soft water)
Consumption
You can display the total
consumption.
Options
– Previous programme
Displays the energy consumption in
the last programme run
– Total consumption
Displays the total consumption to
date
– Reset function
Deletes the total consumption to date
To Next Page
Loading...
Need help?
General
