14
■ Tools needed: 3 mm and 2 mm hex screwdrivers, PH0 x 50 Philips
screwdriver, pliers.
■ Turn off your VBar Control transmitter
■ Remove the neck strap.
■ Put the VBar Control transmitter face down on a soft surface.
1
Remove the six screws M3x20 mm to take off the bottom case. Then ip
the case over so the screws fall out of the bottom case.
■ Flip the still-closed transmitter 90° to the left, and carefully start open-
ing VBar Control like a book.
■ Carefully disconnect the both switch wires and the vibration alarm
motor, and open the VBar Control fully, like a book.
■ Do not touch the main board!
2
Locate and unscrew the metal brakes from the existing throttle stick.
■ If the stick mode is already OK for you, just remove the stepped brake.
3
Unplug the wire going through the plastic brake.
4
Unscrew the plastic brake on one end and unhinge it on the other end.
5
Reconnect the wire, make sure to x it in the plastic clip.
6
Unscrew spring tensioner of the existing elevator stick (next to the bat-
tery, to the left or to the right).
■ Gently unhinge the spring and remove both the plastic holder and the
spring.
7
Remove the metal bracket by gently pulling it out, away from where the
spring was attached.
8
Disconnect the wire which now has to go through the plastic brake.
9
Carefully thread it through the opening in the plastic brake and x the
wire in the plastic clip.
■ Re-connect the wire.
0
Fix the metal brake and tighten to your liking.
■ Use the inner holes for a smooth brake feeling, or the outer holes for a
stepped brake feeling.
q
Place the metal bracket 180° from it’s original position on the other side,
under the future elevator stick.
■ Take care that everything is rotated 180° compared to where you
dismounted the parts.
w
Put the plastic holder in the slot, and hinge the spring to the bracket and
the plastic holder. You may use the cable tie from the USB lead, and
form a hook to handle the spring.
■ Adjust the springs on all sticks to your liking.
■ Carefully close the VBar Control again, and re-connect the switch
wires and the vibration alarm motor.
■ Carefully replace the bottom case,
■ Fasten the six screws but do not over-tighten them.
■ To change the stick length, carefully twist the upper half of the stick
counter-clockwise to loosen the stick, while holding the lower half.
Adjust the lower and the upper half to the length of your choice. Fix the
stick by twisting both halves against each other.
1
To Next Page
Loading...
Need help?
General
