74
Pellerin Milnor Corporation
NOTE: This assembly used on models produced from 2/14/06 (for earlier design, see
BMP050078).
Legend
N1..Adjustment: Insure the switch face is parallel to target by rotating the
mounting plate on the bar and tightening the split collar.
N2..Adjustment: Gap between target and switch sensor should be 3/16”
[9mm]. Adjust the gap by sliding the mounting ring on slotted holes on
mounting brackets.
P1..Pocket 1
P2..Pocket 2
S...Speed Sensor
T...Target
Autospot Installation
2 Sheets
4244WP2 SM
BPWD4I04 / 2020285
BPWD4I04.1 0000296791 A.3 A.6 7/9/20 10:26 AM Released
Bearing Assemblies
To Next Page
Loading...
Need help?
General
