3-14 System Installation
2D scanner 1D scanner
3.5 System Configuration
3.5.1 Running the System
Connect the AC power; make sure the ultrasound system and other optional devices are correctly
connected.
When the AC power indicator on the control panel is light on (indicator
is in green), press the
power button
on the control panel to turn on the system.
3.5.2 Enter Doppler
After system is turned on and wait for about 1 minute (for system initialization), it will enter into
Doppler interface, see the figure below:
Bracket
Bracket
Scanning surface
To Next Page
Loading...
Need help?
General
