11-20 Patient Data Management
2. Click [Add] to enter the following page.
3. Enter the user name (you are not allowed to enter the same name or modify the name
already exist).
4. Enter the password and the confirm password (the password is consist of 6-16
characters)
5. Set the user role in the drop-down list: administrator or operator.
6. Click [OK] to confirm the setting and exit the dialogue box, then the new user will
appear on the User List.
Delete a User
Premise: you must log on the system as the system administrator. If not, you will be
required to enter administrator name and password before the setting.
1. Open the “Admin” page through the path: [Setup]→[System Preset]→[Admin].
2. Select the user to be deleted in the User List (Emergency user can’t be deleted), click
[Delete] to delete the selected user.
11.9.5 Modify Password
The system administrator can modify password of all users.
The operator can only modify his/her own password.
To modify the password, the user has to log on the system first.
There are two ways to modify password: modify it on “Admin” page or on “Session
Manage” dialogue box.
“Admin” page (administrator can modify the password)
(1) Open the “Admin” page through the path: [Setup]→[System Preset]→[Admin].
(2) Select the user name to be modified (except emergency operator) in User List,
click [Change Password] to open the dialogue box (see the figure below).
(3) Enter new password and confirm password, then click [OK].
To Next Page
Loading...
Need help?
General
