Command Mode - Configuration & Operation
34
Operation Menu/Bypass/4. List Bypass
A list of devices may be bypassed using this option. The user is prompted to enter the loop number associated with
these devices.
Next enter the address list of devices you wish to bypass. Use the following symbols to enter the address list:
The message displayed if the current address carries no device is as follows:
The following message is displayed to bypass.
If the device is already bypassed the message is as follows.
If the exclamation is not used, then there will be individual confirmation.
At the end of the bypass operation or if the exclamation is used, the message will be . . .
Operation Menu/Bypass/5. List Unbypass
A list of devices can be bypassed using this option. The user is prompted to enter the loop number to be
unbypassed.
Enter the list to unbypass, the last list bypassed will be displayed.
Comma (press key number 1 three times) Use to separate the addresses of the devices
Dash (press key number 1 two times) Use dash for interval of consecutive addresses, e.g. 1-7.
Exclamation (press key number 1 four times) Placed at the end of list to signify that no individual
confirmation is required.
Loop
Unbypassed
Loop number
Loop :__
Enter bypass list...
xxxxxxxxxxxxxx
Lp:x Addr:xxx
Empty Address
Lp:x Addr:xxx
Bypass? Y/N
Lp:x Addr:xxx
Already Bypassed
Device/circuit
bypassed
Done...
Loop number
Loop :__
Enter bypass list...
xxxxxxxxxxxxxx
To Next Page
Loading...
Need help?
General
