Tire pressure monitoring system (if so equipped)
5-56 Features and controls
N00518900306
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-55, you can resume the previously set
speed by pressing the RES + switch (C) while
driving at a speed of about 25 mph (40 km/h)
or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
The CRUISE CONTROL ON/OFF
switch is pressed.
[Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the “OFF” or
“ACC” position.
[Vehicles equipped with the F.A.S.T.-key]
Put the operation mode in OFF or ACC.
Indicator is turned OFF.
N00530201609
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
To resume the set speed
Tire pressure monitoring
system (if so equipped)
The compact spare wheel does not have a
tire inflation pressure sensor.
When the spare tire is used, the tire pres-
sure monitoring system will not work
properly.
See an authorized Mitsubishi Motors
dealer as soon as possible to replace or
repair the original tire.
The tire pressure monitoring system is not a
substitute for regularly checking tire infla-
tion pressures.
Be sure to check the tire inflation pressures
as described in “Tires” on page 9-12.
The tire inflation pressure sensor (A) is
installed in the illustrated location.
• On vehicles with Type 1 sensor which has
the metallic air valve (B), replace grommet
and washer (C) with a new one when the
tire is replaced.
• On vehicles with Type 2 sensor which has
the rubber air valve (D), replace rubber air
valve (D) with a new one when the tire is
replaced.
BK0235100US.book 56 ページ ２０１５年１１月２０日 金曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
