• Back-up light bulb
Pull the bulb out.
• Rear turn signal light bulb
Turn the bulb counterclockwise while
pressing in.
6. To install the bulb, perform the removal
steps in reverse.
N00944001426
1. Push the light unit (A) toward the left side
of the vehicle to remove it.
2. Turn the socket (B) counterclockwise to
remove it, and then pull the bulb out from
the socket.
3. To install the bulb, perform the removal
steps in reverse.
N00945100166
In order to maintain the value of your vehicle,
perform regular maintenance using the proper
materials and procedures. Be sure to use only
those materials and procedures that meet your
local environmental pollution control regula-
tions. Choose the materials you will use care-
fully, to be sure that they do not contain
corrosives. If you are not sure, contact an
authorized Mitsubishi Motors dealer for help
in choosing these materials.
When mounting the lamp unit, align the
notch (G) and pin (H) on the lamp unit with
the clip (I) and hole (J) in the body.
When installing the light unit, first insert the
tab (C) into the hole on the body, and then
push on the light unit to fit it into place.
Vehicle care precautions
BK0235100US.book 33 ページ ２０１５年１１月２０日 金曜日 午後３時１２分
To Next Page
Loading...
Need help?
General
