NOTE
l
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the lever towards you.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” po-
sition.
l
It is possible to modify functions as follows:
• The time that the headlamps remain on
can be changed.
• The coming home light function can be
deactivated.
For further information, please contact
your MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make
the adjustment. Refer to the separate own-
er’s manual for details.
Headlamp levelling
E00517400031
Headlamp levelling switch (except for
vehicles with discharge headlamps)
E00517500511
The angle of the headlamp beam varies depending
on the load carried by the vehicle.
The headlamp levelling switch can be used to ad-
just the headlamp illumination distance (when the
lower beam is illuminated) so that the headlamps’
glare does not distract other drivers.
Set the switch according to the following table.
CAUTION
l
Always perform adjustments before driv-
ing.
Do not attempt to adjust while driving, as
it could cause an accident.
5 - person seat
Vehi-
cle
condi-
tion
Switch
posi-
tion
“0” “0” “1”
“2” or
“3”
“2” or
“3” or
“4”
●: 1 person
: Full luggage loading
Instruments and controls
3-46
3