Dead Lock System*
E00305100185
The Dead Lock System helps to prevent theft.
When the keyless entry system or the keyless oper-
ation system has been used to lock all of the doors
and the tailgate, the Dead Lock System makes it im-
possible to unlock the doors using the inside lock
knobs.
CAUTION
l
Do not set the Dead Lock System when
someone is inside the vehicle. With the
Dead Lock System set, it is not possible to
unlock the doors using the inside lock
knobs. If you erroneously set the Dead
Lock System, unlock the doors using the
UNLOCK switch on the remote control
switch or using the keyless operation func-
tion.
Setting the system
E00305200216
1. Turn the ignition switch to the “LOCK” posi-
tion.
Also, if a key was used to start the engine, re-
move the key from the ignition switch.
2. Get out of the vehicle. Close all of the doors
and the tailgate.
3. Press the LOCK switch (A) on the remote
control switch, the driver’s or front passen-
ger’s door lock/unlock switch (B), or the tail-
gate LOCK switch (C) to lock all of the
doors and the tailgate. The turn-signal lamps
will blink once.
4. Press the switch again within 2 seconds.
The turn-signal lamps will blink three times
to show that the Dead Lock System has been
set.
Except for vehicles equipped with the keyless operation
system
Vehicles equipped with the keyless operation system
Driver’s and front passenger’s door lock/unlock switches*
NOTE
l
Pressing the LOCK switch (A) on the remote
control switch once while the Dead Lock Sys-
tem is set causes the turn-signal lamps to
blink three times, so it is possible to confirm
that the Dead Lock System is set.
Cancelling the system
E00305300220
When the following operation is performed, the
doors and tailgate will unlock and the Dead Lock
System will be simultaneously cancelled.
Locking and unlocking
1-29
1