10
DEVICE EXPLANATION
10.2 Internal User Devices
10.2.9 Step relay (S)
10 - 28
9
Parameters
10
Device Explanation
11
CPU Module Processing
Time
12
Procedure for Writing
Program to CPU ModuleAppendicesIndex
10.2.9 Step relay (S)
Step relays are devices for SFC programs.
Refer to the following manual for how to use the step relays.
QCPU (Q Mode)/QnACPU Programming Manual (SFC)
POINT
Because the step relay is a device exclusively for the SFC program, it cannot be
used as an internal relay in the sequence program.
If used in this manner a SFC error will occur, and system operation will be stopped
(system down).
To Next Page
Loading...
Need help?
General
