Mitsubishi Q03UD(E)CPU User Manual

10 - 107
10.12 Other Devices
10.12.1 SFC block device (BL)
10
DEVICE EXPLANATION
10.12 Other Devices
10.12.1 SFC block device (BL)
This device is used for checking if the block designated by the SFC program is valid.
Refer to the following manual for how to use the SFC block device.
QCPU (Q Mode)/QnACPU Programming Manual (SFC)
10.12.2 SFC transition device (TR)Note30
This device is used for checking if a forced transition is designated for a specified
transition condition in a specified SFC program block.
Refer to the following manual for how to use the SFC transition device.
QCPU (Q Mode)/QnACPU Programming Manual (SFC)
10.12.3 Network No. designation device (J)
(1) Definition
The network No. designation device is used to designate the network No. in link
instructions.
(2) Designating network No. designation device
The network No. designation device is designated in the link instruction as shown in
Figure 10.91.
Remark
Refer to the following manual for the link instructions.
Q Corresponding MELSECNET/H Network System Reference Manual
Note30
Figure 10.91 How to specify the network No. designation device
UD
Universal
Note10.28
Note10.28
Basic
The Basic model QCPU and Universal model QCPU cannot use the SFC transition device (TR).
UD
Universal
Note10.28Note10.28
Basic
JP.READ
S1 S2 S3 DJn
Instruction name
Network No. designation
device (n: network No.)
Network No.
designation instruction

Mitsubishi Q03UD(E)CPU Specifications

General

Brand	Mitsubishi
Model	Q03UD(E)CPU
Category	Controller
Language	English