If there is no channel with matched Talkgroup ID and
trunk system ID, the radio display shows the channel
alias of <DYNAMIC talkgroup>.
Once the radio is connected, you hear a dynamic
regroup tone, the radio display shows <DYNAMIC
channel> with temporary green color intelligent
backlight and you hear a Voice Announcement.
Note: When the radio loss the GPS signal the GPS
icon blinks and the radio sounds two high-pitched
tones repetitively to indicate GPS fails to operate. The
radio display shows red intelligent light.
Note: If the first matched channel is not configured
with Voice Announcement, no Voice Announcement
is played.
The system sends a message to your radio. The
radio display shows a direct text message content
without any user operation. This message indicates
you are currently present in a Geofence area. This
TMS remains open on the display until user presses
exit/home to exit this screen.
Note: If there is another incoming text message
before you exit the previous message, the message
screen shall be refreshed to show the latest
message.
The following procedure guides you to exit the text
message received.
Press the Menu Select button below Exit or
to return to Home screen.
The other operations are the same as normal
dynamic regroup command.
When the radio exits the Geofence area, your radio
reverts to original channel or newly assigned
talkgroup. The radio display shows the new channel
together with Voice Announcement to indicate the
changes. Voice Announcement of the new channel
only works if that channel is configured with Voice
Announcement.
Trunking System Controls
Using the Failsoft System
The failsoft system ensures continuous radio
communications during a trunked system failure. If a
trunking system fails completely, the radio goes into
failsoft operation and automatically switches to its
failsoft channel.
During failsoft operation, your radio transmits and
receives in conventional operation on a
138
English
To Next Page
Loading...
Need help?
General
