Introduction to this Manual
Related Information
MC3000 Digital Deskset Operator and Installation Manual 1-7
(6880309L15-A)
Dangerous Procedure Warnings
Warnings, such as the example below, precede potentially dangerous procedures
throughout this manual. Instructions contained in the warnings must be followed.
Electrical Safety Advisory
Because of the risk of electrical surges, typically lightning transients, which are very
destructive to customer terminal equipment connected to AC power sources, we recom-
mend that the customer should install an AC surge arrestor in the AC outlet to which the
MC3000 Deskset is connected.
FCC Interference Warning
RADIO AND TELEVISION INTERFERENCE
Related Information
• Motorola R56—Standards and Guidelines for Communications Sites (6881089E50);
also available on CD-ROM (9882904Y01).
• User documentation for the digital radio types: ASTRO, MCS2000, iDEN and LTR
WARNING: THE VOLTAGES EMPLOYED IN THIS EQUIPMENT ARE SUFFI-
CIENTLY HIGH TO ENDANGER HUMAN LIFE. EVERY REASONABLE PRECAU-
TION HAS BEEN OBSERVED IN DESIGN TO SAFEGUARD THE OPERATING
PERSONNEL. OPERATING PERSONNEL SHOULD BE PROHIBITED FROM TAM-
PERING WITH PROTECTIVE DEVICES SUCH AS DOOR SWITCHES. THE
POWER SHOULD BE REMOVED COMPLETELY AND THE HIGH VOLTAGE
CAPACITORS IN POWER SUPPLIES DISCHARGED MANUALLY WITH A SHORT-
ING BAR BEFORE MAKING INTERNAL ADJUSTMENTS.
WARNING: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
WARNING: In order to maintain compliance with the FCC regulations, shielded
cables must be used with this equipment. Operation with non-approved equip-
ment or unsaddled cables is likely to result in interference to radio and televi-
sion reception.
To Next Page
Loading...
Need help?
General