Installation
Configuring and Testing Deskset Functions
2-14 MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)
Configuring and Testing Deskset Functions
The power must be connected before you can configure the deskset’s parameter values
and test the deskset functions. Once in the Configuration and Test program, the LCD dis-
play shows two lines; the first line states which of the configurations or tests you are cur-
rently performing and the second line states which of the parameters/functions you are
setting or testing. The program has 18 menu options where options 1 - 7 are tests and
options 8 - 18 are configuration settings.
If the deskset is powered off while modifying the configuration, the changes will not be
saved.You must exit the Configuration and Test menu to save the configuration settings.
The Configuration and Test program has a main menu and a sub-menu, except for option
# 6 “SW Number”.
The Configuration and Test program uses the following buttons on the front console:
•The Mode Up button moves up one option in the main menu and sub-menu.
•The Mode Down button moves down one option in the menu and sub-menu.
•The Shift button works with the Sel button to enter the test program.
•The Menu/Home button allows you to enter and exit a sub-menu
•The Sel button allows you to exit the test program from the main menu.
Tests
To enter the Configuration and Test program:
1. Press and hold the Shift button and then press the Sel button. When you enter the
test program, the first line of the LCD Display will show the “Button Test” and the sec-
ond line will show “Press Menu”.
2. At any time you can press and hold the Mode Up or Down buttons to move up or
down the menu options. Options (1 - 7) on the menu are tests you can run.
To enter and exit a sub-menu:
1. When a sub-menu is available from the main menu, press the Menu/Home button to
enter and exit the sub-menu.
2. At any time you can press and hold the Mode Up or Down buttons to move up or
down the sub-menu items.
3. In the sub-menu, select the desired sub-menu option and press the Menu/Home but-
ton to exit the sub-menu.
To exit the Configuration and Test program:
1. In the main menu, press the Sel button to exit the Configuration and Test program.
Note: Once in the Configuration and Test program, the following options (1 - 7) on the
menu are tests:
To Next Page
Loading...
Need help?
General