Installation
Opening Deskset
2-6 MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)
Opening Deskset
Although most connections are made from the back of the deskset, interface connections
for alarms and jumper settings are made inside the deskset housing.
To open the deskset housing:
1. Gently, lay the deskset face-down and remove the four screws on the outside corners
of the back housing.
2. Holding the back and front sides of the housing together, turn the deskset face-up.
3. Separate the front housing from the rear housing, starting at the top and opening the
console toward you. The two sides have a ribbon cable connecting them at the bottom
of the console housing.
Figure 2-5: Bottom of Deskset
Figure 2-6: Separating Front from Rear Housing
2 screws
at back
2 screws
at front
To Next Page
Loading...
Need help?
General