Installation
Connecting Deskset to Alarms
MC3000 Digital Deskset Operator and Installation Manual 2-7
(6880309L15-A)
Connecting Deskset to Alarms
Alarm connections are made to a terminal strip on the right side of the bottom housing.
The pins are numbered in ascending order from left to right (inside to the outside of the
bottom housing).
The deskset must be opened for access to this terminal strip.
To connect the deskset to alarms:
1. Put the cable through the slot on the bottom rear corner of the housing.
2. Loosen the 4 slotted screws on the each terminal strip and insert the cable wires into
the correct positions as shown in the following three tables.
3. Secure and tie-wrap the cable to the bottom housing.
Note: After the power supply is connected you can apply power and perform a verification
test.
Setting Jumpers
The deskset must be opened for access to the jumpers. You must remove power prior to
opening the deskset. If you are connecting a deskmic, all jumpers are in position A. If you
are connecting a headset, all jumpers are in position B.
Table 2-1: P2 Alarm Functions Terminal Strip Table
Pin # Function
1 Alarm_com (common)
2 Alarm _NC (normally closed)
3 Alarm _NO (normally open)
4Ground
Table 2-2: Jumper Settings Table
Switch Position Function *= Default
S1 A *Enable PTT control for Deskmic
S1 B Enable PTT control for Headset
S2 A *Enable Monitor for Deskmic
S2 B Enable Monitor for Headset
S4 A *Enable Deskmic Sense for Deskmic
S4 B Enable Headset Sense for Headset
To Next Page
Loading...
Need help?
General