Multiplex FreshBlender User Manual

Part Number: WBL-95-156 REV002 11
Section 1 General Information
SYSTEM PRESSURES
Water Supply to the Unit
n
Warning
Do not supply more than 80 psi (0.551 MPa , 551 kPa,
5.51 bar) Plain or Carbonated Water to the unit, excessive
pressure to product pumps may cause failure.
This table shows the Minimum / Maximum supply of Water
required at the rear of the machine at no flow conditions.
MINIMUM MAXIMUM
Plain Water
Supply
40 psi
(0.276 MPa , 276 kPa, 2.76 bar)
80 psi
(0.552 MPa, 552 kPa, 5.52 bar)
Important
Minimum water pressure supplied to the machine needs
to be greater than the 35 psi (0.241 MPa , 241 kPa, 2.41
bar) required during flowing conditions for pressure to
be regulated properly.
REGULATOR SETTINGS & LOCATION
Models FB081TF
NOTE: The regulator is located behind the left side panel.
Plain Water
Regulator
35 psi
(0.241 MPa , 241
kPa, 2.41 bar)
Flowing
Regulator Settings
Important
Water requires the pressure measurement to be taken
only when rinse water is spraying or dispensing (flowing
conditions).
Important
Water pressure affects the blender area cleaning, a
water booster may be required if pressure is too low.
REGULATOR SETTINGS (During Flowing Conditions)
Plain Water
35 psi
(0.241 MPa , 241 kPa, 2.41 bar)

Multiplex FreshBlender Specifications

General

Brand	Multiplex
Model	FreshBlender
Category	Dispenser
Language	English