Multiplex FreshBlender User Manual

Part Number: WBL-95-156 REV002 47
Section 4 Maintenance
Prepare Refrigerated Base
1. Make sure all 8 product flavor bags present and connected.
n
Warning
All 8 slots need either a product bag or a cap over the
product sanitation fitting of the motor assembly in
order to clean or water/cleaner/sanitizer will flow into
the cabinet during the cleaning process.
1. Install a product flavor bag or a cap over product
sanitation fitting if slot is empty.
2. Repeat for each empty slot.
3. Close bottom door.
4. Press Next when ready to continue.
Prepare to Clean
1. Open the top door.
2. Connect the cleaning hose to the CIP pump connector.
3. Place the other end into the bucket with mild dish
detergent solution.
4. Place the bottomless cleaning cup in shuttle.
5. Press Confirm button to start the Rinse/Cleaning Process.
First Rinse Process
The screen will display the line rinsing progress for each line
where fresh water is flushed through all product lines then
automatically proceed to Prime lines with cleaner for the
CIP (Clean In Place) process.
Cleaning Process
The screen will display the line cleaning progress for each
line then automatically proceed to the Soak Time screen
then second Rinse Process.
Second Rinse Process
The screen will display the line rinsing progress for each line
where fresh water is flushed through all product lines. The
screen will prompt user when done.

Multiplex FreshBlender Specifications

General

Brand	Multiplex
Model	FreshBlender
Category	Dispenser
Language	English