66 Part Number: WBL-95-156 REV002
Maintenance Section 4
19. Wipe the inner ice bin wall with descaler solution. Rinse
and wipe dry. Repeat with sanitizer solution. Rinse and
wipe dry.
20. With a bottle brush, clean the ice nozzle at bottom
of ice bin with descaler solution. Rinse and wipe dry.
Repeat with sanitizer solution. Rinse and wipe dry.
21. Replace all cleaned parts in their correct positions:
• Assembled Dispense Wheel/Plates
• Auger
• Bin Cover
• Motor and six (6) thumbscrews
22. Plug unit back into power source and power ON the
unit by moving the power rocker switch to the ON
position.
23. After approximately 15 minutes the compressor will kick
on and the ice machine will make ice with the sanitizer
solution then begin to deposit the ice in the bin.
24. Make ice for 20 minutes, adding sanitizer solution as
the water level in the reservoir drops.
NOTE: Do not allow the sanitizer solution level to drop
below the sensing probes. The ice machine will start a 20
minute delay period if the sensing probes lose contact with
the water for more than 10 seconds. If this happens refill the
reservoir and power cycle the unit to start over.
25. After making ice for 20 minutes evacuate all sanitizer
solution from the reservoir and evaporator by entering
the Service screen> Service Outputs> Cleaning and
toggling the Ice Maker Dump Valve ON until all solution
has been emptied from the system then toggle OFF.
26. Power down the unit by moving the power rocker
switch to the OFF position.
27. Reconnect the water supply line quick connect in the
back of the unit, place the top and left panels back onto
the unit
28. Power ON the unit by moving the power rocker switch
to the ON position.
NOTE: Startup delay after power cycle will take approximately
15 minutes before the compressor will turn on.
29. After the startup delay, allow the ice machine to make
ice for 20 minutes.
n
Warning
This ice production will contain residual cleaning
chemicals and must be discarded.
30. After 20 minutes power cycle the unit by turning the
rocker switch to the OFF position, waiting 30 seconds
then ON.
31. Empty all ice from the ice bin by entering the Service
screen> Service Outputs> Dispense & Blend and toggling
the Ice Motor ON until all ice has been dispensed from the
ice bin, discard all ice produced.
32. Logout of the Service screen and allow the ice maker
to make ice for 20 minutes before putting the unit back
into use.
NOTE: Ice Calibration may be required. See “Product, Ice, &
Water Calibration” on page 31
To Next Page
Loading...
Need help?
General
