Chapter 2 Installation and Configuration
© National Instruments 2-15 NI PXI-8109 User Manual
Hard Drive BBS Priorities Submenu
• Boot Option #1, Boot Option #2, Boot Option #3—These settings
specify the boot priority of hard drive devices. The highest priority
device is displayed on the main Boot Option Priorities list.
Optionally, each device can also be Disabled if the device should
never be used as a boot device.
CD/DVD ROM Drive BBS Priorities Submenu
• Boot Option #1, Boot Option #2, Boot Option #3—These settings
specify the boot priority of CD/DVD ROM drive devices. The highest
priority device is displayed on the main Boot Option Priorities list.
Optionally, each device can also be Disabled if the device should never
be used as a boot device.
Floppy Drive BBS Priorities Submenu
• Boot Option #1, Boot Option #2, Boot Option #3—These settings
specify the boot priority of floppy drive devices. The highest priority
device is displayed on the main Boot Option Priorities list.
Optionally, each device can also be Disabled if the device should
never be used as a boot device.
Network Device BBS Priorities Submenu
• Boot Option #1, Boot Option #2, Boot Option #3—These settings
specify the boot priority of network devices. The highest priority
device is displayed on the main Boot Option Priorities list.
Optionally, each device can also be Disabled if the device should
never be used as a boot device.
Security Menu
Use this menu to enable BIOS security options.
• Setup Administrator Password—This setting specifies a password
that must be entered to access the BIOS setup. If only the
Administrator’s password is set, then this only limits access to the
BIOS setup program and is only asked for when entering the BIOS
setup program. By default, no password is specified.
• User Password—This setting specifies a password that must be
entered to access the BIOS setup or to boot the system. If only the
User’s password is set, then this is a power on password and must be
entered to boot or enter the BIOS setup program. In the BIOS setup
program, the User will have Administrator rights. By default,
no password is specified.
To Next Page
Loading...
Need help?
General
