Chapter 2 Installation and Configuration
NI PXI-8109 User Manual 2-20 ni.com
4. (Optional) Enter a name for the RT target in the Name text box.
5. (Optional) Set the network configuration options of the RT target in the
IP Settings section and click the Apply button.
For information about configuring network settings, refer to the
Configuring Network Settings book, accessible by browsing to
MAX Remote Systems Help»LabVIEW Real-Time Target
Configuration»Configuring Network Settings from the Contents
tab of MAX Help.
Note When any IP or identification settings are changed, you will be prompted to reboot
the controller for the changes to take effect. Click Yes to automatically reboot the RT
target. You may also reboot the controller by right-clicking on the target name under
Remote Systems and selecting Reboot.
After rebooting the PXI controller it will appear in the Remote Systems
category with the assigned name.
6. Expand the PXI controller view in the Remote Systems branch and
select Software.
7. Click the Add/Remove Software button in the toolbar to launch the
LabVIEW Real-Time Software Wizard.
8. Install the LabVIEW Real-Time software and device drivers that you
require on the RT target. Refer to the NI Web site at
ni.com/info and
enter the Info Code
etspc for the latest information about supported
software.
After installation of the software the controller will automatically reboot
and you will now be able to program it using LabVIEW Real-Time.
Note Refer to the RT Getting Started Guide available on your host computer for more
information about setting up your RT target.
LabVIEW RT Configuration Switches
Use the LabVIEW RT configuration switches to configure LabVIEW RT
if it is installed on the controller. If you are not using LabVIEW RT, these
switches should remain in the OFF position. The controller reads these
switches only after a system reset.
Note You must reboot the controller for any changes to take place.
To Next Page
Loading...
Need help?
General
