Page 23/40
Start screening:
Select the Patient to be screened:
• To select a Patient already added to the To-Do list, on the Home
screen, tap To-Do List and select the patient, and select start screen,
or select protocol, and start screen depending on your device settings
• To select a patient already on the device but not yet in the To-Do list,
on the Home screen, tap Patient List, select the baby by tapping on
the Patient Name, and select start screen, or select protocol, and start
screen depending on your device settings
• To add a new patient to the device and then start screening, tap New
Patient and enter the patient information and select start screen, or
select protocol, and start screen depending on your device settings.
If you want to start screening immediately and enter Patient data during screening, touch “Speed
Screen”. You will be directed to the Screening display and measurement will automatically start, if
ATA Cable and Patient Cable are connected properly to the device. You can then enter the patient’s
data by tapping on the individual field using the touch screen display.
3.5.8 Troubleshooting
If an error occurs with your device please check the below list and proceed as recommended in Table
4. Further information about Troubleshooting can be found in section 3.5.4: Hardware Tests or in the
online FAQ (www.pathme.de/support/faq).
To Next Page
Loading...
Need help?
General
