26
TO HOLD A CALL
Press key. Held line wink flashes.
To Retrieve
Lift handset or press key.
Press held line. Use handset to converse.
If unanswered
After preprogrammed time, Automatic Recall is ini-
tiated.
Visual and audible signal (rapid flash and ring
burst) is sent to station that placed call on hold.
Hold shows as a flashing green LED on your phone.
The same line on other phones shows as a flashing
red LED. Recall shows as a flashing green LED on
your phone and flashing red LED on other phones with
the same line.
TO TRANSFER A CALL
After conversing, ask party to hold.
Press key. Receive interrupted dial tone.
Dial destination station’s extension, hang up or wait
for answer.
If transferring party hangs up, that station’s number
appears in the center of recipient’s display.
Note:
If held line appears on other DT Series stations,
the associated LED flashes red slowly.
Note:
Any station with this line appearance can retrieve
the call.
To Next Page
Loading...
Need help?
General