Hardware installation
1. Connect the power adapter to the Power socket on the back of the NF8AC.
2. Plug the power adapter into the wall socket and switch on the power.
3. Wait approximately 60 seconds for the NF8AC to power up.
Connecting via a cable
1. Connect the yellow Ethernet cable provided to one of the ports marked ‘LAN’ at the back of the NF8AC.
2. Connect the other end of the yellow Ethernet cable to your computer.
3. Wait approximately 30 seconds for the connection to establish.
4. Open your Web browser, and enter http://192.168.20.1 into the address bar and press enter.
5. Follow the steps to set up your NF8AC.
Connecting wirelessly
1. Ensure Wi-Fi is enabled on your device (e.g. computer/laptop/smartphone).
2. Scan for wireless networks in your area and connect to the network name that matches the Wireless network name
configured on the NF8AC.
Note: Refer to the included Wireless Security Card for the default SSID and wireless security key of your NF8AC
3. When prompted for your wireless security settings, enter the Wireless security key configured on the NF8AC.
4. Wait approximately 30 seconds for the connection to establish.
5. Open your Web browser, and enter http://192.168.20.1 into the address bar and press Enter.
6. Follow the steps to set up your NF8AC.
To Next Page
Loading...
Need help?
General
