ENGLISH – 21
EN
8.2 CONNECTING THE IBT4N INTERFACE
The control unit is equipped with a “IBT4N”-type connector for
the IBT4N interface, which allows for connecting all devices
equipped with BusT4 interface, such as, for example, Oview
programmers and the IT4WIFI Wi-Fi interface.
The Oview programmer allows for comprehensively and rapidly
managing the installation, maintenance and diagnosis of the en-
tire automated system.
f
Before connecting the interface, disconnect the
power supply to the control unit.
To install the interface (“Figure 24”):
1. remove the cover of the control unit’s containment box
2. place the interface (A) in the appropriate slot (B) on the
control unit’s electronic board
3. insert the cable (C) in the appropriate slot (D) on the in-
terface
4. put the cover of the control unit’s containment box back
on.
At this stage, the control unit can be powered again.
B
A
D
C
24
l
For further information, consult the specic manu-
als of the connected devices.
PRODUCT MAINTENANCE
9
9 PRODUCT MAINTENANCE
Being an electronic part, the control unit does not require any
special maintenance. Nonetheless, the system should be reg-
ularly checked to ensure that it works efciently at least every
6 months according to the instructions in the “TESTING AND
COMMISSIONING” chapter.
PRODUCT DISPOSAL
10
10 PRODUCT DISPOSAL
l
This product is an integral part of the operator and
must therefore be disposed of with it.
As with the installation, only qualied personnel must dismantle
the product at the end of its life.
This product is composed of different types of materials. Some
of these materials can be recycled; others must be disposed of.
Please enquire about the recycling or disposal systems in place
in your local area for this type of product.
a
WARNING
Some parts of the product may contain polluting or
dangerous substances. If not disposed of correctly,
these substances may have a damaging effect on
the environment and human health.
l
As indicated by the symbol shown
here, this product must not been
disposed of with household
waste. Separate the waste for dis-
posal and recycling, following the
methods stipulated by local reg-
ulations, or return the product to
the seller when purchasing a new
product.
a
WARNING
Local regulations may impose heavy penalties if
this product is not disposed of in compliance with
the law.
To Next Page
Loading...
Need help?
General
