Nice RUN Series User Manual

15
EN
TECHNICAL SPECIFICATIONS OF PRODUCT
WARNINGS: •Alltechnicalspecicationsstatedinthissectionrefertoanambienttemperatureof20°C(±5°C).•NiceS.p.a.reservestherighttoapply
modicationstoproductsatanytimewhendeemednecessary,maintainingthesameintendeduseandfunctionality.
Model:
RUN1500
RUN1200HS
Type Electromechanical gearmotor for automatic movement of sliding gates for industrial use complete with elec-
tronic control unit.
Pinion
Maximumtorqueonstart-up[cor-
respondstoabilityofgeneratingthe
forcerequiredtomovetheleaf]
35Nm
(1000N)
27.4Nm
(790N)
Nominaltorque[correspondstothe
ability of generating the force to main-
tain the leaf in movement]
20Nm
(560N)
10.3Nm
(286N)
Speed(noload)
15 m/min
22 m/min
Speed(atnominaltorque)
10.8 m/min
19 m/min
Maximumfrequencyofoperating
cycles(atnominaltorque)
15 cycles/hour (365 cycles/day), for a gate of 15m
(equal to a cycle of 63%), (
15 cycles/hour (365 cycles/day), for a gate of 15m
(equal to a cycle of 63%), (the control unit limits cycles
tothemaximumnumberspeciedintables2and3)**
Maximum time of continuous
operation(atnominaltorque)
60 minutes (the control unit limits continuous
operation tothemaximumlimitsasspecifiedintables
2and3)***
60 minutes (the control unit limits continuous operation
tothemaximumlimitsasspeciedintables2and3)***
Operating limits IngeneralRUNisdesignedfortheautomationofgateswiththeweightsandlengthsasspecied
Durability Estimatedbetween150.000cyclesand450.000cyclesaccordingtoconditionsspeciedinTable4
Power:RUN400HS-1200HS 230VAC(+10%-15%)50Hz.
Maximum power absorption on
start-up[correspondingtoAmps]
700W
(3,5A)
700W
(3,5A)
Maximum power absorption on start-
up[correspondingtoAmps]
400W
(1,8A)
400W
(1,8A)
Insulation class 1 (safety earthing required)
Flashing light output For 2 Flashing lights LUCYB (lamp 12V, 21W)
Gateopenindicatoroutput For 1 24V lamo of maximum 4W (output voltage may vary between -30 and +50% and can also control small
relays)
BLUEBUS output One output with a maximum load of 15 BlueBus units
STOP input Fornormallyclosedornormallyopencontacts,for8.2kΩconstantresistance;withself-recognition(anyvaria-
tionfromthememorizedstatuscausesthe“STOP”command)
Step-by-step input For normally open contacts (contact closure generates S.S. command)
OPEN input For normally open contacts (contact closure generates OPEN command)
CLOSE input For normally open contacts (contact closure generates the CLOSE command)
Radioconnector SM connector for receivers SMXI; SMXIS or ONEXI
RadioANTENNAinput InputANTENNARadio52ΩforcabletypeRG58orsimilar
Programmable functions 8 ON-OFF type functions and 8 settable function (see tables 7 and 9)
Functionsinself-learningmode Self-learning of devices connected to BlueBus output
Self-learningof“STOP”devicetype(contactNO,NCor8,2KΩresistance)
Self-learning of gate length and calculation of deceleration and partial opening points
Operating temperature -20°C ÷ 50°C
Useinacid,salineorpotentiallyexplo-
sive atmosphere
No
Protection rating IP 44
Dimensionsandweight 400 x 255 h 390; 24.5kg

Nice RUN Series Specifications

General

Brand	Nice
Model	RUN Series
Category	Gate Opener
Language	English