30 – English
The manoeuvre is carried out but the device
connected to the FLASH output does not work
Ensure that the device connected to the “FLASH” output is as programmed. When the
device is powered, ensure that there is voltage present on the device terminal; if there is
voltage, the problem is due to the device; in this case replace the device with one having
the same characteristics; if there is no voltage, there is an overload on the output.
Check that the cable has not short-circuited.
F2
F1
16
11
SCRAPPING
This product is an integral part of the automation and must be scrapped with it.
RVGDMHMRS@KKHMFSGDOQNCTBSVGDMSGDOQNCTBSQD@BGDRSGDDMCNEHSRRDQUHBDKHEDHSLTRSADRBQ@OODCAX@PT@KHjDCSDBGMHBH@M
This product comprises various types of materials: some may be recycled others must be disposed of. Seek information on the recycling and
disposal systems available in your area for this product category.
WARNING! Some parts of the product may contain pollutants or hazardous substances which, if released into the environment,
may cause serious damage to the environment or human health.
As indicated by the symbol, the product may not be disposed of as domestic waste. Sort the materials for disposal, according
to the methods envisaged by current legislation in your area, or return the product to the retailer when purchasing a new version.
:$51,1*/RFDOOHJLVODWLRQPD\LQFOXGHWKHDSSOLFDWLRQRIVHULRXVƄQHVLQWKHHYHQWRILPSURSHUGLVSRVDORI
this product.
12
MAINTENANCE
This charter provides information about how to draw up a maintenance schedule of SPIN.
The automation must be subjected to maintenance work on a regular basis, in order to guarantee it lasts.
The maintenance operations must be performed in strict compliance with the safety directions provided in this manual and
according to the applicable legislation and standards.
If other devices are present, follow the directions provided in the corresponding maintenance schedule.
01. SPIN requires scheduled maintenance work every 6 months or 3,000 manoeuvres (max.) after previous maintenance.
02. Disconnect the power supply and buffer batteries, if featured.
03. Check for any deterioration of the components which form the automation, paying particular attention to erosion or oxidation of the
structural parts. Replace any parts which are below the required standard.
04. Check the wear and tear on the moving parts: belt, carriage, pinions and the door components; if necessary replace them.
05. Connect the electric power sources up again, and carry out the testing and checks provided for in Paragraph “7.1”.
To Next Page
Loading...
Need help?
General
