VBA10201-R.3577.A
- A40
･
-
Shooting Image Adjustment
1. Outline
When you replace a part of the D100 image system or TFT display system or a part shown on the table in P.
A39, make adjustment with the D100 image adjustment software (J65043). This chapter will describe the
adjustment and handling of this software.
2. Functions of adjustment software
(1) Sensitivity adjustment
(2) Color sensitivity ratio adjustment
(3) CCD GrGb level compensation adjustment
(4) Open aperture sensitivity compensation
(5) Battery check level adjustment
(6) Built-in speed light adjustment
(7) TFT display position adjustment
(8) CCD-EEPROM Flashram up
(9) TFT-EEPROM Flashram up
(10) CCD defect compensation
* When replacing the CCD unit, perform only "CCD-EEPROM Flashram up" and "CCD defect compensation".
* Before performing “Sensitivity adjustment”, “CCD GrGb level compensation adjustment” and “Color
sensitivity ratio adjustment”, acquire the reference values by using a reference body.
3. Environment for operation
Applicable OS: Windows98SE, Windows2000, Windows Me and Windows XP
Necessary input/output port: 1 or more for USB
Screen size: Screen of 1024×768 pixels or more is recommended.
4. How to set up
Make an optional directory in the hard disk of PC and copy the following les required for the operation of this
software.
• Q50ImageAdjustENG.EXE: Application le
• NkdStor.dll: USB communication application extension
• STD.DAT: Standard storing le
* Copy the above les in the same directory.
5. Installation of hardware
When using this software, it is necessary to connect D100 with USB and install the hardware driver. This work
is different according to OS. In Windows2000 and Windows XP, connect D100 with USB. Installation of
driver is not necessary.
For Windows98SE, its special driver must be installed.
To Next Page
Loading...
Need help?
General
