Safety Precautions
E-4
WARNING and CAUTION for Using the TS100/TS100-F
1. Do not disassemble.
Disassembly may cause malfunction and/or electrical shock, and will lead to the forfeiture of all claims
against warranty. Do not disassemble any part other than those described in this manual. If you
experience any problem with the microscope, contact your nearest Nikon representative.
2. Read the instructions thoroughly.
To ensure safety, thoroughly read this manual and the manuals for other equipment to be used with
this product. In particular, be sure to follow the warnings and cautions at the beginning of the manuals.
3. Input voltage
Make sure that the input voltage indicated on two places (on the nameplate and on the immediate right
of the AC inlet at the microscope's rear) are the same as your local voltage. Do not use the microscope
if the local voltage differs from that required by the microscope. Follow the instructions below if this is
the case. Use of the microscope under the incorrect voltage may cause over-heating due to
over-current, possibly resulting in a fire and damaging the microscope.
• If the voltage indicated on the nameplate differs from local voltage, do not turn on the power but
contact your nearest Nikon representative immediately.
• If the voltage indicated to the immediate right of the AC inlet differs from local voltage, change the
input voltage setting as described on P.33 before turning on the power. The following values may be
set for the input voltage.
• If the nameplate reads “100/110/120 V ~”, the input voltage may be set to 100, 110 or 120 V
AC. (Factory setting: 120 V AC)
• If the nameplate reads “220/230/240 V ~”, the input voltage may be set to 220, 230 or 240 V
AC. (Factory setting: 240 V AC)
4. Use only the specified lamp and fuse.
Use only the specified lamp and fuse. Use of other lamp and fuse may result in damage to the
microscope or fire.
• Specified lamp: Halogen lamp 6 V-30 W (PHILIPS 5761)
• Specified fuse: 250V, 1A, time-lag, low-breaking type 5x20 miniature fuse x2
Input voltage indications
WARNING
To Next Page
Loading...
Need help?
General
