9/2022 A - 27 56091272 - Advance SC4000
ENGLISH - AINSTRUCTIONS FOR USE
OPERATING THE MACHINE
WARNING!
Be sure you understand the operator controls and their functions.
While on ramps or inclines, avoid sudden stops. Avoid abrupt sharp turns. Use low speed down ramps.
STARTING THE MACHINE
1 Follow the instructions in “Preparing the Machine for Use” section of this manual and verify the following;
• Batteries are fully charged.
• Exterior of machine is free of damage. Report any damage to your supervisor.
• Proper brushes is correctly installed.
• Squeegee is installed.
• Solution tank is full.
• Recovery tank is empty.
• Ensure that area to be scrubbed is clear of obstacles that are not xed, such as hoses, buckets or pails, boxes, electrical cords, carts,
pallets, etc.
WARNING!
Do not dispense ammable cleaning agents, operate the machine on or near these agents, or operate in areas
where ammable liquids exist.
2 Refer to illustrations on pages 8-11 if needed. Sit in the Operator’s Seat (2), adjust the seat to a comfortable position using the Seat
Adjustment Lever under the seat.
3 Place the Magnetic SmartKey (39) into the SmartKey Reader (22) on the machine. Press the Power Switch (H) to turn ON the machine.
4 Reference the Battery Indicator (C3). and Hour Meter (C1) before proceeding.
5 To transport the machine to the work area apply even pressure with your foot to the front of Drive Pedal (3) to go forward. For reverse, rst
press Reverse Paddle (D). Reverse Indicator (C27) will appear on the display then apply even pressure with your foot to the front of Drive
Pedal (3). An audible alert will sound in reverse.
6 Adjust machine speed by varying the pressure on the Drive Pedal (3).
D
E
F-
G
C10
C1
C3
C5
25
23
24
28
31
32
33
29
30
AA
C26
C1
C2
C3
C4
C5
C8C7
C6
C10
C12
C11
C9
C25
C14 C15 C21
C22
C23
C16 C17 C18 C19 C20
C24
C27
STOPPING THE MACHINE
1 Stop the machine by releasing the Drive Pedal (3).
2 ONLY IN THE EVENT OF AN EMERGENCY!
To stop all machine functions immediately, press the Emergency Stop (A).
• The display will show Emergency Stop Activated Indicator (C20).
• To reset the machine functions, rotate the emergency stop clockwise.
To Next Page
Loading...
Need help?
General
