Nokia A032 Getting Started Guide

Supplementary information
29
4. Supplementary information
Operating modes and LED status
Startup mode
Startup mode occurs from the time power is
applied until the unit is operating normally.
During the startup mode the
alert LED will be
on or flashing. The info LEDs reflect the three
phases of startup mode:
• Self test phase– The
info LEDs all come on
and then go off.
• Initialization phase – The
info LEDs go on
and off in sequence.
• Diagnostics phase – The Access Point runs
diagnostics during initialization. If an error
is found during this phase the initialization
stops and an error code is displayed on the
info LEDs (see Initialization error codes on
page 34). If no errors are found, the unit
will enter Normal mode.
Normal mode
During normal operation, the info LEDs show
the percentage utilization of the wireless LAN
connection. In this mode the upper row of
symbols (
busy) applies.
Notes:
The alert LED also
flashes during internal
flash memory updates.
Do not power off while
the alert LED is
flashing.
Don’t press the mode
button during startup
unless you have read
and understood
Special modes on
page 30.

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English