3
Mount the ONT facing the wall using the wall mount bracket (3FE 49471 AA).
a. Determine the location of the two anchor holes for the wall mount bracket. The bracket can
be used as a template for marking and drilling the holes.
It is recommended to use a level to ensure that the ONT unit is installed properly.
b. Drill two holes 35 mm (1.37 in.) depth into the wall and with the centers spaced 157 mm (6.2
in.).
c. Insert the two mounting screws and optional anchors into the holes, leaving a 2 mm (0.078
in.) gap between the screw head and the wall.
d. At this point, perform a test to ensure that the wall mount bracket fits securely over the screw
heads. Mount the bracket flush to the wall so that it does not warp or twist.
e. Remove the wall mount bracket from the wall.
f. On a flat surface such as a desk, install the ONT into the wall mount bracket by lifting the unit
above the bracket and sliding it downward onto the bottom ledge of the bracket.
g. Seat the ONT into the wall mount bracket by engaging the hooks on the base of the unit with
those on the bracket. Engaging the hooks ensures that the ONT stays in place while the unit
is mounted onto the wall.
h. Mount the unit onto the wall.
Figure 6-5 ONT in wall mount bracket—facing the room
POWER
PO
N
INTERNET
TEL
WPS
WLAN
USB
36994
Install a XS-2426G-B indoor ONT
Wall mount an XS-2426G-B indoor ONT
Nokia ONT
Review Review
December 2021
Issue 1 71
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
To Next Page
Loading...
Need help?
General
