Getting started > 22
P
OWER
SAVING
MODE
If you do not use the machine for a while, it will enter power saving mode to control the
power consumption of the device. To cancel or initiate power saving mode, press the
Power Save button on the control panel.
NOTE
If your machine is connected locally (via USB), when it transitions to Sleep
mode its status is viewed as off-line. To use the printer in this state, you must
press the Power Save button to exit sleep mode.
By default, the time interval to enter the power saving mode is set to 1
minute. Refer to “Power Save Time” on page 187.
You can enable or disable the power saving mode. Refer to “Power Save
Enable” on page 188.
To Next Page
Loading...
Need help?
General
