USG-400
ISSUE1 3-15 Installation and Connection
6 Connection of footswitch (optional)
There are two kinds of footswitches, the THUNDERBEAT and SONICBEAT footswitches. This section
describes how to connect these footswitches.
WARNING
Do not connect any equipment other than the optional
footswitch to the footswitch socket. Otherwise, the system
cannot perform appropriately and injury and/or equipment
damage may also result.
CAUTION
Do not place a heavy object, such as a trolley (cart), on the
footswitch cable. Otherwise, cable disconnection may result.
Do not drop to the footswitch.
Always hold the footswitch plug section when connecting or
disconnecting it. Otherwise, the cable may separate from the
footswitch plug.
Avoid applying excessive force to the cable and the end of
the footswitch plug when connecting the footswitch plug.
Otherwise, the cable may separate from the plug or other
failure may result. If it is expected that the cable may be
subject to excessive force, move the ultrasonic generator
and footswitch to appropriate positions.
Connection of the footswitch for THUNDERBEAT
1. Checking the footswitch
Confirm that the footswitch cable and footswitch plug are free of damage
and that the pedals are free of cracks or separation (see Figure 3.15).
Figure 3.15
2. Checking the footswitch pedal operation
Press each pedal and confirm that it functions smoothly.
3. Checking the position of the footswitch plug and footswitch socket
Align the index (red circle) on the footswitch plug with the index (red circle)
on the THUNDERBEAT footswitch socket (silver) on the rear panel of the
ultrasonic generator (see Figure 3.16).
To Next Page
Loading...
Need help?
General
