Omron 3G3RX-V1 Series User Manual

10．Appendix 2 Setting Procedure without the Configuration Files
10.2. Work Flow of the "Procedure for Setting Parameters from the Beginning"
The following is the procedure for making connection settings for remote I/O communications
of the DeviceNet using the "procedure for setting parameters from the beginning".
This section describes the detailed procedures for "10.3 Setting up the Controller without the
Configuration Files" and "10.4 Setting up the Network by CX-Integrator" (in red frames below)
to make settings with software without using "configuration files".
For details on the procedures for 7.3 Setting the Inverter, 7.4.1 Hardware Setting for the
DeviceNet Master Unit, and 7.6 Checking the Connection Status, refer to Section 7 because
they are the same as the "procedure for using the configuration files".
7.3 Setting Up the Inverter Set up the Inverter.
↓
7.3.1. Hardware Setting Mount the DeviceNet Communications Unit on the
Inverter.
↓
7.3.2. Parameter Setting Set the parameters for the Inverter.
↓
10.3. Setting Up the Controller Using
the Software
Set up the Controller using the software.
↓
7.4.1 Hardware Setting for the
DeviceNet Unit
Set the hardware switches on the DeviceNet Unit
and connect to the Controller.
↓
10.3.2. Starting the Sysmac Studio and
Setting Parameters for the
Controller
Start the Sysmac Studio and set the parameters for
the Controller.
↓
10.3.3. Setting Global Variables Set global variables used for the remote I/O
communications.
↓
10.3.4. Connecting Online and
Transferring the Project Data
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
↓
10.3.5. Settings in Watch Tab Page Make settings in the Watch Tab Page to check data
that are sent and received.
↓
45

Omron 3G3RX-V1 Series Specifications

General

Brand	Omron
Model	3G3RX-V1 Series
Category	Inverter
Language	English