To Next Page

To Previous Page

1 Introduction

1 - 4

E5@C Digital Temperature Controllers User’s Manual (H174)

 Event Inputs

• With any model that supports event inputs, you can use external contact or transistor inputs to

achieve any of the following functions: Switching set points (Multi-SP No. Switch, 8 points max.),

switching RUN/STOP, switching between automatic and manual operation, starting/resetting the

program, inverting direct/reverse operation, switching the SP mode100% AT execute/cancel, 40%

AT execute/cancel, setting change enable/disable, communications write enable/disable, and

canceling the alarm latch.

 Communications Functions

With any E5@C model that supports communications, you can use CompoWay/F, Modbus-RTU,

programless, and component communications.

*1 Modbus is a registered trademark of Schneider Electric.

*2 The E5CC-U does not support communications.

 Transfer Output

With any model that provides a transfer output, you can output the set point, process value,

manipulated variable, or other values as a 4 to 20-mA or 1 to 5-V transfer output. The E5CC-U*,

E5DC*, E5DC-B and E5GC do not have a transfer output, but if the control output is a linear current

output, the control output can be used as a simple transfer output.

* The E5CC-U must be manufactured in May 2014 or later (version 2.2 or higher) and the E5DC must be

manufactured in July 2014 or later (version 2.2 or higher).

 Remote SP Input

With any model that provides a remote SP input, you can set the set point with an analog input.

* The E5CC-U, E5DC, E5GC, E5CC-B, or E5DC-B does not have a remote SP input.

Omron E5CC User Manual

Other manuals for Omron E5CC