Omron SYSMAC CP2E-N D Series User Manual

8-3
8 Overview of Built-in Functions and Allocations
CP2E CPU Unit Software User’s Manual(W614)
8-2 Overall Procedure for Using CP2E Built-in Functions
8
8-2 Overall Procedure for Using CP2E
Built-in Functions
The overall procedure for using built-in CP2E functions is described in this section.
1
Select the functions to use.
Example: Interrupts, high-speed counter
inputs, and pulse outputs.
2
Set the functions with the applicable numbers
using the CX-Programmer.
Example: Using input interrupt IN3 and high-
speed counter 0, parameters in the
PLC Setup must be set for the fol-
lowing functions.
Refer to Section 7
PLC Setup and 8-3
Terminal Alloca-
tions for Built-in
Functions.
• Input interrupts
• Quick-response inputs
• High-speed counters
• Origin searches
• Minimum cycle time
• Serial communications
• Ethernet
• Analog Option Board
3
Write ladder diagrams using the CX-Pro-
grammer.
Example: Permitting interrupts with the
MSKS instruction and program-
ming high-speed counters with the
CTBL instruction.
Example: Stopping high-speed counters.
Refer to A-2 Auxil-
iary Area Allocations
by Address.
Example: Reading the present value of a
high-speed counter.
4
Transfer the PLC Setup and ladder program
from the CX-Programmer to the CP2E CPU
Unit.
5
Once turn OFF the power supply to the CP2E
CPU Unit, then turn ON again.
6
Start the CP2E CPU Unit operation.
Select Functions
Make the Settings in
the PLC Setup
Special Instructions
Writing Related
Auxiliary Area Words
Reading Related
Auxiliary Area Words
Create Ladder Program
Transfer PLC Setup
and Ladder Program
Restart the CP2E
Start Operation

Omron SYSMAC CP2E-N D Series Specifications

General

Brand	Omron
Model	SYSMAC CP2E-N D Series
Category	Computer Hardware
Language	English